Loudspeaker Placement

The Audio Note AN-E/La is a highly versatile loudspeaker which will provide satisfying performance in most listening environments.

For optimal tonal balance, the AN-E/La should be used on a stand of 24 - 27cm (10 inches) in height, for best results, use spiked high-mass stands that can hold the speaker so firmly that even if the top of the speaker is pushed, it will not move at all.

Alternatively, light open-frame stands will give decent results provided they have spikes rigidly coupling them to the floor, (through carpet if present.)

The speakers should be coupled to the stand by placing four pea-sized balls of Blu Tack on the stand’s top and pushing the speaker down onto these so that they are flattened. (We have included
some of this Blu Tack with the instructions and warranty card.)

The AN-E/La has very wide dispersion which provides a great deal of flexibility in the different rooms and set ups, and despite being a rear ported design it is designed for corner or near wall, much of the set up process is therefore counter intuitive in that it works in the opposite way to “normal” loudspeaker set up (for example move the speaker CLOSER to the rear wall will normally result in a tightening and deepening of the bass reproduction), so bear that in mind when you do the initial set up and later adjustments.

The AN-E has, as a result of its wide dispersion, a very wide listening window, allowing considerable angling (or toe-in) to provide an evenly distributed energy window between the speakers, by allowing adjustment of early sidewall reflections either by adjusting the frequency content to coincide an underpin the direct sound or from interfering with the direct sound from the speakers. These reflections will greatly affect tonal and stereo balance and even relatively small changes in the speaker’s angle and distance to the side wall can change the room interaction markedly.

To control these reflections, place the outer edges of the speakers as close to the side wall as possible, shortening the time difference between direct sound and first reflections as much as possible. The optimal angle at which the speakers are aimed at the listener varies from room to room, especially the room size will have a marked influence on the angling and proximity to the side walls, where these are available.

The object of the setting up exercise is to find a position where the speakers pressurize the room in a similar way to that of natural instruments, this will restore a much overlooked aspect of music reproduction, the actual pressure generated by instruments, which is one of the main differences between “live” and “reproduced”.

Four main options
(presented from most to least desirable, all else being equal)

1.) Starting with rooms where corner position is available

Move the speaker to be as close to the side wall as possible, to the point of almost touching the wall, with the speaker 5 – 10 centimeter (2-4 inches) from the rear wall, toe the speakers in to aim 1-2 meters (3-6 feet) in front of the listener, now play a record or CD with some bass content to see how the low frequencies come across, then adjust the speaker angle to get a good and even energy spread between the speakers.

2.) Then to rooms with only real walls available, as a rule always fire down the long length of the room wherever possible, otherwise also follow the clues below

Place the speaker 5 – 10 centimeters (2-4 inches) from the rear wall, then toe them in to aim almost directly at the listener, especially in large rooms this should be tried, even in corner position, give them a listen, then move the speakers as far apart from each other as the room allows, then play with the distance between the speakers and the angle, to create the best possible balance (compromise) between the bass response and the energy distribution between the speakers, (remember the angle of the speaker to the wall can be anything from a few degrees to 45 degrees or sometimes even more, depending on the distance between the speakers and the distance to the listening position. Lastly try to move the speakers forward 5 centimeter (2 inches) to see how the bass behaves, adjust distance t rear wall to get the bass and deep and even as possible.

3.) Now to really difficult rooms, such as rooms where little or no wall space is available or very long and narrow rooms for example

Position the speaker facing each other, believe it or not the AN-E’s dispersion is so good that this position in some rare instances work better than any alternatives, in a narrow long room, the speakers can be positioned using the side walls the way the rear walls are used in 2.) above, but with the speakers at a very steep angle seen from the listening position, then essentially follow the instructions in 2.) above.

4.) Lastly rooms where the speaker can only be used free standing

Due to our speaker’s near wall design requirements this is the least desirable position, as it will not allow pressurization of the room in the way or to the extent we intend, nor will it therefore give you the best frequency balance, however our speakers still sound better than most in this, the most undesirable position, and as a rule the speakers should be angled to cross about a meter in front of the listener and form an equidistant triangle if used this way.

Needless to say, regardless of how thorough I try to be in these set up instructions, experimentation is vitally important to achieve optimum results in any given environment and over time as you familiarize yourself with the sound of the speakers in your room you will be able to refine and optimize the set up.

All material copyright Audio Note (UK) Ltd., unless otherwise stated. Audio Note (UK) Ltd. reserve the right to change, modify, add to, or remove any of the content of this site at any time without prior notice. Further, images on this site may differ from current models or specifications.